[u/Josh]

Originally Posted by EarlQHan

The rates are off. Shankenstein has already done the base estimates:

http://www.ft86club.com/forums/showp...38&postcount=1

I think there may be a mistake in his post because I am getting the front rate to be 131 lb/in = 22,000 N/m. I'll plug that number in tomorrow and check the results.

And it seems my damping coefficient was way off as well. I don't remember where I got this plot from but it is probably useful to some of you. This is a front stock BRZ damper. I'll try 6700 N*s/m.