Quote:
Originally Posted by FRankenStein
Before adapters. Possible rocket bunny kit on its way if they work though
|
If you run 10mm adapters you could get it to fit up front but with a but load of negative camber, fender pull, and stretching tires. Definitely doable though... Rears are definitely more of a concern IMO... Stock body and actually making em sit inside the fender or close to it would be tough.
Also if you go with RB kit you're going to end up getting pretty big spacers to get the fitment anywhere close to flush(30mm+). Know I see a lot of guys running 10.5 +22's in the rear and still end up getting spacers that push em well into the negative offsets.
Here's a good reference for you(for the rears) and stock body:
10.5 width with a +32 et, you can see how much poke there is... Add a 10mm or 15mm adapter and it only gets harder
http://www.ft86club.com/forums/showthread.php?t=23831