View Single Post
Old 04-15-2013, 12:17 PM   #7360
ronnBOi720
Asphalt FR-s
 
ronnBOi720's Avatar
 
Join Date: Jan 2013
Drives: 2013 Scion FR-S
Location: YUMA AZ
Posts: 391
Thanks: 184
Thanked 87 Times in 66 Posts
Mentioned: 2 Post(s)
Tagged: 0 Thread(s)
Quote:
Originally Posted by Supermassive View Post
@ronnBOi720

Injectors and fuel pump are pointless for a non FI car, you will only see the limits of the injectors at about 280WHP where you run into a brick wall as far as duty cycles on the stock injectors. I'm running 700cc Deatschwerks injectors with a 290lph fuel pump at the moment which is overkill for my current tune, but I can crank my boost to the moon once I decide to.

The best bang for the buck is to get the Ecutek tune and go E85. Buy a decent intake and then start saving for the P&L or Nameless header, and then grab a nice header back exhaust.

Some other nice things to have is the lightweight crank pulley and buy yourself a Clutchmasters FX100 clutch/flywheel if you arent auto...those two paired together transform the character of the engine. Other than that there's a few things that make sense, an air/oil separator (catch can) is a sound investment, I was skeptical at first but since getting mine, it might just become one of the first mods of any future car I own. Also invest in some Motul or Pentosin tranny fluid if you have a manual, makes a big difference. Other than that theres not much else to do unless you want to go FI
ok so i was looking into this e85 tune and everything. i found this...
http://ft86speedfactory.com/ecutek-e...cable-458.html

talks about the tune, license and cable.
__________________
2013 Scion FR-S Asphalt, 5% tint, Invidia n1 exhaust, Cusco front strut bar w/ BCS, Cusco rear strut bar, cusco earth ground kit, Cusco oil catch can, Takeda short ram air intake, custom vinyl
ronnBOi720 is offline   Reply With Quote