Quote:
Originally Posted by HRTROB
Which is the correct part number for the non-fouler? You said to use 42002 or 42009 but the guy on your link posted a link to the ones he used, which were 42006
|
I pm'ed him to clarify. He confirmed it was 42002 or 42009. The difference between those two is tapered edge or using a gasket to seal. I'm honestly not sure which one would be best. They are cheap & plentiful enough that you could buy both and see which one seals best and return one.
I ordered an angled spacer from bigdaddiesgarage.com because I don't want the sensor spaced straight out too close to the body, even though he told me there weren't any clearance issues with the straight spacers. I think the angled spacer I have on the way will allow a bit of extra slack in the wiring which will make me feel better. It's a little more expensive but it's also made out of t304 stainless which should put up with the heat from the headers better over time.