[boead]

Originally Posted by radroach

I get second gear clunk too, but sometimes I think it's because I wasn't engaging the clutch at the shift point correctly, keeping the rpm connected via clutch and speed balanced, etc. That is, if I misshift as a slow mph 1st to 2nd gear near in between 7mph I'll hear an audible click from the drivetrain that you can hear outside the vehicle.

That is, going gentle as you say, I think the problem is that the motion was "too gentle" and didn't start engaging the clutch soon enough at the smooth 2nd gear shift when the engine is at idle, below 10mph and rolling motion. Keeping the momentum and the right inertial points and timing that the engine and trans synchronization to clutch and drive train engagement.

same here and good evaluation!