Quote:
Originally Posted by Calum
I was thinking shoulder-bearing-bolt-knuckle-bolt, but a simple spacer as @ Shit Luck alluded to seems plausible to.
Glad I could contribute an idea to the cause!! :happy0180: |
I will look into it so you can do shoulder-(shim)-bearing-(shim)-knuckle-nut. Since we have a flare under the taper, it alleviates stress in case the tolerance is slightly off. We have our tolerances to .001" in some spots, but the tolerances would need to tightened in a few areas of our design because the taper would need to be SPOT on. That is why it never crossed my mind to do a through bolt/shank.