Not sure if you guys have already reversed this info or not but Thought I would post it up as I am currently trying to understand the effects of DI Injection timing on torque output.. I have some dyno time next week and want to play around with the GDI Firing Angle.. However I'm not really sure what the degrees in the table represent, as it seems to contradict what was said earlier about the timing ranging from BTDC at high rpm to ATDC at low rpm
BTW, all of the GDI injection timing and ratio tables are set the same (hot, cold, warm, cold idle etc etc). After the reading I have done on DI, i thoght for sure the tables would vary so i was a bit surprised to find them all set the same.