SO here are some picts and info on our SUPER HEAVY DUTY COOLING UPGRADE
we are ready to go to market with these this week.
At Robispec we are fans of extra credit work and so we went to an "overkill cooling solution" stock radiator is 15mm core we replace this with 2 25mm tube core add a liquid to liquid oil cooler in the "cold side tank" and have less than 2 feet of total lines to complete the whole "kit".
The best thing about this is that you dont need to thermostaticly control the oil temp (a big potential problem with the Air to liquid cooler solutions) as the water thermostat does this for you and actually heats the oil faster during warm up then stabilizes it to run about 20-30 degrees hotter than the water temp. this is better in many ways than the current kits on the market.
1. lighter overall
2. short hose runs,minimal resistance to flow = no extra strain on the stock oil pump
3. "fixes" the Water cooling issues sure to develop with the stock radiator.
4. Uses existing cooling airflow and leaves fender locations for brake ducting
5. With low profile fans ADDS space in front of the engine for turbo/SC piping
Picts in the car
here are the cores for comparison. BIG PROBLEM and no oil cooler included with the car either.
Even the A/C condensed is thicker than the Stock radiator!(3/4" vs 5/8 ")
here is the BEST solution...to the above problem
system out of the car
This image has been resized. Click this bar to view the full image. The original image is sized 1024x575 and weights 47KB.
This image has been resized. Click this bar to view the full image. The original image is sized 1024x575 and weights 47KB.
This image has been resized. Click this bar to view the full image. The original image is sized 1024x575 and weights 52KB.
This image has been resized. Click this bar to view the full image. The original image is sized 1024x575 and weights 52KB.
This image has been resized. Click this bar to view the full image. The original image is sized 1024x575 and weights 83KB.
This image has been resized. Click this bar to view the full image. The original image is sized 1024x575 and weights 83KB.
This image has been resized. Click this bar to view the full image. The original image is sized 1024x575 and weights 44KB.
This image has been resized. Click this bar to view the full image. The original image is sized 1024x575 and weights 44KB.
This image has been resized. Click this bar to view the full image. The original image is sized 1024x575 and weights 75KB.
This image has been resized. Click this bar to view the full image. The original image is sized 1024x575 and weights 75KB.
can use stock A/C with this.
NO cutting plastec to mount
Cold air over the top as needed
STOCK mounting points used
OVER TRIPLE THE COOLING CAPACITY and an extra Qt of engine oil.
takes 2 hours to install
total system cost Radiator oilcooler takeoff plates hoses, an fittings, fans
EVERYTHING INCLUDED for John Q Public to install $1,195.00
Look for the group buy to save money on the first ten of these.
Robi