View Single Post
Old 01-21-2013, 01:12 AM   #15
scottmcphee
Senior Member
 
scottmcphee's Avatar
 
Join Date: Nov 2012
Drives: 06 Subaru Legacy
Location: Canada
Posts: 291
Thanks: 40
Thanked 119 Times in 81 Posts
Mentioned: 11 Post(s)
Okay next person to go into either door, check out some wires on the power window regulator E5 on left door or F1 on right door. Say which door because they might act different.

What is voltage observed on some wires running between the window switch and window motor, on these pins on the window motor connector:
Pin 5 white wire, when car acc power is active, and again when acc is cold.
Pin 1 white wire/black stripe, when acc power is on, window doing nothing, then again while window rolling up using switch on door. And does voltage change/drop when window reaches top edge? Continue to observe voltage and roll window down.
Pin 3 green wire, same tests as pin1.

Use a good chassis ground point wire for the negative lead on meter.
scottmcphee is offline   Reply With Quote