Quote:
Originally Posted by PMok
I'm thinking if you put a ring of silicone or other similar substance around the gasket before installing it, it will help keep the water out of the back?
|
Good idea. I'm going to order a sheet of 1/4" thick neoprene foam and do exactly that after I cut the templates out. I might cut 2 sets out so I can also test the stock tail light housings with the thicker sealed gaskets.
By the way, when removing the tail light housings, the 4 nuts holding it on are 8mm (5/16" works too). Another thread said it was 10mm. A 8mm deep socket or ratcheting wrench are easiest.
I'll document all these steps incase it works well, then I can use it for a DIY.