[xcelir8brz]

Originally Posted by xcelir8brz

Not to dampen anyone's mood, but...

i. I received the package and slowly installed the kit. Everything was triple checked (plugged and unplugged) to make sure all is good. I am an experienced installer.

However...

HELP - MY ENGINE WILL NOT TURN OVER (i.e. start) in either O or I position.


Any ideas? PM me ASAP!

Thank you!

http://www.ft86club.com/forums/showt...t=24864&page=4

FALSE ALERT - FIXED IT - Was a power pin on UNCHIP side of the harness that wasn't set in connector properly. Car starts up fine, cleared a CEL, will test drive in the morning. Whew!