here's some pics...
Camera out of the box:
Camera installed on rear trim:
installed on car:
I utilised the stock trunk lid loom plug for the camera wires too. This plug takes the standard sumitomo terminals used in the majority of late toyota engine bay sensor plugs, available from Ballenger motorsports, Phoenix Tuning etc
http://www.bmotorsports.com/shop/pro...oducts_id/1567 :
Mini Relay with two terminals soldered on that clip into the headunit's camera power positions, one of the larger red wires is tapped into the headunit ignition switched 12V wire, the other larger red wire runs to the camera:
Completed body-side loom ready to install:
Loom installed in-car:
video from camera:
The lines on that screen are the default ones from the actual BOYO camera. To get the headunit's built-in lines I need to use the other rear camera input on the back of the headunit and cut the blue wire on the boyo loom to disable the boyo's own lines.