Greetings Ya'all
As part of my VEERRY drawn out personalisation of my '86 I have decided to make up my very own badges.
These are all a modification of the "86" logo.. I have only completed the 3D print of the front page.. it is based on the Toyota badge size wise and seats the 86 logo inside the classic Toyota Oval
The rear trunk badge will be an enlarged version of the side "86" logo, complete with the stylised boxed engine emblem.. this will be about 3.5 times larger than the normal side ones.
Front and back badges will either be finished in coloured pewter or colour anodised or powder coated aluminium.
I will have the 3D print of the rear badge to show early next week..
Ok so here is a white print of the badge in situ.. the 86 logo stands proud.. the angle makes it look a little weird but I wanted it to be chunky
From the side
Slightly wider front view
The badge in hand to give an idea of size and detail
And a close up of the badge in place... we have made the little pins at the back so it will mount up perfectly in place with some 3M tape
