Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB - View Single Post - Unofficial - CEL/SL/Idle Issue List for FR-S/BRZ Owners

tbertran · 10-03-2012, 12:51 AM

As per my earlier post, got her back after 5 days in the shop. So far so good...

Here is the summary of the work done from the invoice:
(this part seems to be the initial diagnostic from 9/27)

Code:

VERIFIED CHECK ENGINE LIGHT IS ON, EXTRACTED CODE POO19 : CAMSHAFT POSITION CORRELATION (BANK 2 SENSOR B.) . MOVED B10CV TO B2 LOCATION. CLEARED THE ECM: AND PERFORMED TEST MODE A AS PER TECH LINE INSTRUCTION. RECHECKED FOR CODES AND FOUND CODE P0019 STORED. WILL NEED TO REPLACE BANK 1 EXHAUST CAM GEAR AND PERFORM TEST MODE A.

(this part seems to be the final diagnostic as of 10/2, FYI Tom Blamey is the Subaru field rep in the Sacramento area)

Code:

WAS CONTACTED BY TOM BLAMEY INVOLVING A REFLASH OF THE ECM.TOM BLAMEY INSTALLED REFLASH OF THE ECM-CLEARED THE CODE. PERFORM TEST MODE A AND RETEST DRIVE 43MILES TO SEE IF CODE WOULD RETURN. NO FAULTS OCCURED AT THIS TIME.ADVISE CUSTOMER TO MONITOR.

Any idea what "MOVED B10CV TO B2 LOCATION" means?

10-03-2012, 12:51 AM	#1017
tbertran Senior Member Join Date: Sep 2012 Drives: Subaru BRZ (6027xx) Premium Manual Location: Sacramento, CA Posts: 280 Thanks: 83 Thanked 171 Times in 85 Posts Mentioned: 5 Post(s) Tagged: 0 Thread(s)	As per my earlier post, got her back after 5 days in the shop. So far so good... Here is the summary of the work done from the invoice: (this part seems to be the initial diagnostic from 9/27) Code: VERIFIED CHECK ENGINE LIGHT IS ON, EXTRACTED CODE POO19 : CAMSHAFT POSITION CORRELATION (BANK 2 SENSOR B.) . MOVED B10CV TO B2 LOCATION. CLEARED THE ECM: AND PERFORMED TEST MODE A AS PER TECH LINE INSTRUCTION. RECHECKED FOR CODES AND FOUND CODE P0019 STORED. WILL NEED TO REPLACE BANK 1 EXHAUST CAM GEAR AND PERFORM TEST MODE A. (this part seems to be the final diagnostic as of 10/2, FYI Tom Blamey is the Subaru field rep in the Sacramento area) Code: WAS CONTACTED BY TOM BLAMEY INVOLVING A REFLASH OF THE ECM.TOM BLAMEY INSTALLED REFLASH OF THE ECM-CLEARED THE CODE. PERFORM TEST MODE A AND RETEST DRIVE 43MILES TO SEE IF CODE WOULD RETURN. NO FAULTS OCCURED AT THIS TIME.ADVISE CUSTOMER TO MONITOR. Any idea what "MOVED B10CV TO B2 LOCATION" means?