Quote:
Originally Posted by 450hp/tonne
Being carefull here, but:
A) I haven't seen anything publicly released on this, so I will have to suggest an OBDII data logger. You'll find that hours of fun anyway ...
|
I have one but unfortunately I can only access the data stream for "Engine Timing", not the Cam Shaft Position data for the four shafts. I am looking into a suitable Toyota/Subaru CAN-BUS compatible setup I could afford.
If worse comes to worse I could try to connect an O-Scope to the crank shaft and cam position sensors (getting those probes in there to clear the belt would be a pain in the a$$ but doable). It would be pretty hard to drive with that setup tho...