[Philius]

Originally Posted by CBR600RR

Unfortunately I don't have any pics of the process, but it is really simple.

1. Place your order with Carson Toyota (FT86 vendor) for the JDM side fender 86 piston badge.

2. Remove the old badge using fishing line and your GF's hair dryer. (hair dryer to heat up the scion badge and the adheasive behind it. fishing line to kinda 'saw' the adheasive behind the badge)

3. Once you have the badge off use goo gone and a microfiber on the remaining adheasive.

4. Take your 86 piston badge and cut off the guide pins on the back side with a sharp exacto blade. make sure that they do not stick out past the back profile, so the badge can sit flush.

5. Remove the adheasive cover on the back of the badge. line up the badge to center and covering all the old guide holes on the trunk lid. then stick it on. (NOTE: once the adheasive touches the paint you will not be able to adjust the badge at all without removing it just like you did with the scion badge, so be careful and be accurate)

thanks man