I took the FRS badge off the rear in preparation for all the JDM badges that should arrive in a day or so. I will post pics when the new ones get put on.
Taking the FRS was a breeze thanks to my Auto trim and molding tool set that I picked up from Harbor Freight. Best $6 I have spent in a while.
http://www.harborfreight.com/5-piece...set-67021.html
Just wedge the tool between the body and the badge and pull up. Do this around the out side edge of the badge and pull it up a section at a time. Eventually you can just pull the whole badge up. If you care about the badge be careful because the only thing holding it together is the little "-" in the FR-S and that could snap easily.
Then I used a heat gun on the low setting and pulled up the glue with my finger nails. Last step is to remove any residue with denatured alcohol.
