|
So I noticed the bog today in several gears when I tried to give it WOT at around 2K RPM. It was a violent bog, to the point that I was afraid it was going to stall out the motor.
I checked all the fittings on the intake, put it back together again, disconnected the battery to reset, then let it idle for a few minutes. Took it out for a drive and still had a bog. Shut off my AC, drove around some more, and tested it out again - no bog whatsoever. Turned my AC back on, tested it out - still no bog. Whats up with that? Perhaps I just needed to let it run for a while after the reset?
I'm on the 1.02 93 STG1 map. Only performance mods are AIRAID intake, Visconti flash, and Perrin lightweight crank pulley.
Those of you who experienced violent bogging, was your AC on?
|