Dropped on a K&N air filter,
http://www.ft86club.com/forums/showt...833#post378833 Sounds better, I had kept the stock air box on my WRX wagon, It worked real well since I was under the 350 hp mark. There are some nice threads here that I will emulate.
These are the parts I will more than likely go with.
Tanabe Coilovers TSE4166 ~ 2190.00
Tanabe DP T50166 ~ 240.00
Tanabe Tour Medallion T70166 ~ 1340.00
Tanabe Front Strut Bar TB166F ~ 139.00
Tanabe Rear Strut Bar TB166R ~ 139.00
Tanabe Front Sway Bar TSB166F ~ 245.00
Tanabe Rear Sway Bar TSB166R ~ 245.00
I'd like to match all my parts similar to the wagon was, only variant there was the tomei header. If they decide to do a header for the FRS I'm sure I'm flexible enough to make the concesion, It was debendable, well made with quality materials.
I had to go to dealer and find where they had the body plugs that were not in the glove box from where they hooked it on the transport. I also set up a meeting with the Toyota representative to show him some paint issues as far as quality goes.