I decided to take a look and see if I had a crack on the taillight assembly that is described in the TSB.
I saw no cracks, but I did notice the following...
- The foam piece in the back of my taillight is only glued on the top. Not sure if that is normal or not, but I was able to drain the water in the back of my taillight assembly by lifting the bottom up like a flap (pic below).
- There are circle shaped tears around all four of the bolts (pic below). Again, not sure if that is normal or not, but I didn't see this in the PDF of the TSB.
- I was able to drain a lot of the water that was stuck in my taillight by just tilting the taillight in different directions. The two places that I noticed the water coming out of was from the turn signal and from two of the four circle tears (pic below).
Water in taillights for over a week.
Water sitting in the back of the taillight assembly
Water on foam piece on back of taillight
Closer pic of water in taillight
Notice the rips where you screw in the nut. Looks like imprint of the nut b/c it was screwed on too tight.
