|
Last event of the season is done, so here's the current to-do list:
-Going from 550lb rear springs to 650lb and getting rid of the rear bar all together
-Going from a 10mm front spacer to 25mm
-Adding an OS Giken tuned by Shaftworks
-Throwing that in a 3.73 final drive diff
-Figuring out an oil cooler solution, but leaning towards a JR Dual Rad knowing it will likely not be enough for sustained sessions but we'll never know unless I try it. So, do that before cutting holes in splitters.
-Adding some tire spats
-Taking some awesome 3D printed parts DocWalt sent me and getting them installed. Intake snorkel and some splitter bracket pin guide rods.
-General systems check on the suspension parts to check bearings, etc
Possible list if the holidays deals are good enough:
-Apex SM10RS in 17x10
-RLCAs
-Might even go to a Zebulon splitter now that I made it a season without destroying the less-expensive Racebred splitter
|