[bryansuriel3]

I have a 2013 Subaru brz limited it's been sitting for 3 years due to a blown motor I purchased a used motor from Jdm motors and swapped everything to that new motor and installed it into the car I attached every connector swapped most of the fuses that show the amps I haven't checked the relays the car cranks but does not start.

The obd2 port doesn't work and the windows wont go down also the car doesn't lock/unlock itself seems as if the door isn't powered. The ac display doesn't work the seat warmer button, mirror adjuster and the wipers

Things that do work is the dash , the dome light, doors floor lights, high beam too Ive swapped fuses in the engine bay and the interior


Update:
the electrical issue was the battery terminal fuse I swapped it I'm able to use my obd now and windows work everything else works
still wont start it cranks but it sounds like a weak crank with flickering going on
I scanned the car 4 permanent codes came up
P0011
p2109
p0345
p0335
i already replaced the crankshaft sensor
and cleared the the codes and its still there

there's a hose on this new engine on top of the cam plate there wasn't one on my original engine i guess what ill do is unbolt it and put a plug unless you guys have any suggestions

as for the crankshaft position sensor plate i completely forgot to install it on to the new engine thanks opie
I'm going to drop the Transmisson instead of pulling the engine again smh
ill keep you guys updated