[RedReplicant]

TechnoToys rear toe links in






SuperPro front lower control arm bushings out, PCI spherical compliance bushing and Hardrace rear spherical in. PCIs look great, the Hardrace are ehhh - they don't seem to be serviceable and everything is glued/compounded together.






The compliance bushings were an absolute breeze to swap, the rear was a slightly different story. Removing the SuperPro was super easy but the Hardrace were press fit tight and there is no way to get it fixtured on my HF press since the bushing is inline with the LCA.

I ended up with an absolute mess of stacked stuff, a balljoint C clamp tool, and old faithful Milwaukee 1/2 impact.

I grabbed a set of RC1s for Chuckwalla, I haven't decided which setup I'm running yet (RE71RS or RC1). Going to string align the car tomorrow, but I think I'm going to try a small amount of rear toe in.