Probably helps if I include the STL for the trunk pull upthread.
Things you need:
- The print
- Pry tool
- CA (optional)
- Loctite Blue (optional)
If metric:
- M4 well nut (8mm OD)
- M4 x 35mm socket head screw
If freedom units:
- 8-32 well nut (5/16th OD)
- 8-32 x 1 3/8th socket head screw
Directions if not obvious:
- Install the well nut in the back recess
- (Optional) wick one drop of CA into the gap
- (Optional) one drop of loctite blue into the threads of the well nut
- Insert the socket head screw into the front, thread it until it just bites
- Pop the push pin of your choice off the trunk liner (if you have one)
- Insert the assembly in, tighten screw until it stops wiggling.
Be aware that loctite blue can slightly melt/lubricate the well nut, causing it to come apart