[strat61caster]

From bottom of pinch weld to top of fender I have ~20.25”-20.4”, my right front fender got dinged and thus sits about an eighth inch higher then the rest. Never wrote down hub center to fender as I can back it out with the info I have, and it’s annoying to measure accurately and with uneven fenders not really all that useful.

So if I have 5” at the pinch weld bottom edge, I’ll have ~25.25” at fender arch, which 24.7 wheel diameter means 13.05” from hub center to fender arch.

This of course depends on how you measure your fender arch whether it’s from the bottom of the rolled portion or from the flat face which is another plus or minus an eighth inch.

fwiw I’m 4.8” from bottom of pinch welds to ground, no rake, ~25” from fender to ground and thus ~12.7” from hub center to fender. That’s a 122mm ride height at the bottom of the pinch welds.

Also, you’re not going to see a huge difference moving your punch weld measurement points back or forward a few inches, if it’s still intact by the wheels or near the door jams that should work just fine.