Quote:
Originally Posted by Joon525
If you (I know it's in an uncomfortable spot) remove the intake inlet, temporarily replace the galley plug, and maybe move the ac compressor to the right you could proceed to de-pin the wire from the connector so you can repair it and then put it all back together.
The thought is that you'll have much more slack to make the repair to the single wire if it's not IN the connector.
Did it get damaged during the installation of the sensor?
Or did the wire rub against the sensor over time with vibration?
|
During the installation. I made a mistake and I think I kinked one or two wires.
Big time rookie mistake
Sent from my iPhone using Tapatalk