Finally getting a little time to work on my own car again, after life deciding it was time for me to get pounded for a bit. A huge pile of parts has amassed over this hiatus
and the engine pieces are at the machine shop getting done.
Started the ball rolling again by beginning to design the wing mounts. Still need to trim a bit of fat off them then I can use my new 3d scanner on the templates to finish the design in fusion
much excite! These are just 6mm alumacore and the final piece will most likely be .250" 7075 AL. I was thinking about using carbon but it would be almost 1k for 2 stupid mounts vs 250.00.
Don't mind the hood in the pic, I need to finish trimming the bottom and install the aero latches.
Engine bay hasn't change much. Finished the coolant tank, breather tank and welded the v-bands on the headers but thats it.
Interior is going to take a little turn as I got my dash from HGK in, sadly no pic as I'm a dummy but you'll see it soon. I plan on moving the fluid reservoirs but the haltech, aim pdm and most electronics will be under the dash on a panel and the dash will be attached with quick turn fastners.
Thats it for now but I'm excited to get rolling again!
