Awesome build!
Quote:
Originally Posted by kask2_6.0
Finished up the PDM wiring this weekend. PDM is controlling the radiator fans, motec ECU, coils, lambda controllers, and reverse lockout solenoid. Some sensors, gps module, and dash control buttons wired into it as well. It’s also taking data from two can buses. On the CAN1 bus I have the Motec and the factory Subaru bus. On CAN2 I have the two AEM lambda controllers and MSEL battery relay. Will be adding the Aim RIO02 module to that bus too when it’s finally released.
|
Been studying up on CAN bus and hope to learn from your setup. The A17 and D43 junction connections were used for your CAN1 and CAN2? Are the devices on CAN2 wired as a new main bus line from D43's 9 & 20 (lambda controllers as stubs, battery relay at the end), with a single terminating resistor?