Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB - View Single Post

chriskep1 · 03-08-2023, 03:13 PM

Hi
I had to replace a front lower control arm and also the steering wheel airbag. I've since repaired all. I now get a code 1231 steering wheel angle sensor abnormal. I replaced the said sensor but still get the same code. I am wondering if there is a way to test the actual sensor itself with a meter and would a need to calibrate the the steering wheel position cause that fault. It reads 0 voltage. I checked the harness and get proper voltage at pins 1 to 4 and there is negligible resistance between pin 1 and the chassis. Thanks in advance for any help/advice.

03-08-2023, 03:13 PM	#1
chriskep1 Junior Member Join Date: Jan 2021 Drives: frs Location: California Posts: 3 Thanks: 0 Thanked 0 Times in 0 Posts Mentioned: 0 Post(s) Tagged: 0 Thread(s)	Steering wheel angle sensor Hi I had to replace a front lower control arm and also the steering wheel airbag. I've since repaired all. I now get a code 1231 steering wheel angle sensor abnormal. I replaced the said sensor but still get the same code. I am wondering if there is a way to test the actual sensor itself with a meter and would a need to calibrate the the steering wheel position cause that fault. It reads 0 voltage. I checked the harness and get proper voltage at pins 1 to 4 and there is negligible resistance between pin 1 and the chassis. Thanks in advance for any help/advice.