View Single Post
Old 01-29-2023, 06:24 PM   #5
MrScrublord
Junior Member
 
Join Date: Feb 2021
Drives: 2013 Subaru BRZ Limited
Location: OR
Posts: 6
Thanks: 0
Thanked 2 Times in 2 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quote:
Originally Posted by humfrz View Post
What code does your car show?

Erase the CEL and see if it comes back.

Switch the #1 coil pack.

Currently the codes on my car P0301 for the misfire and only a couple days ago I had C1201 pop up for the ABS system, I don’t have an ABS dash light on though. I’ve cleared the codes many times before and P0301 always comes back and has always been a permanent code since this problem began. After working on the spark plugs, the permanent code is gone, which makes me feel like I fixed something.
The last thing I did was check the spark plugs, the one in cylinder one was a different model than the other 3 and was gapped way too small. I fixed the gap and then swapped it around to cylinder 2 to see if it was the spark plug, so far no. I plan on replacing the spark plugs soon anyways.
I have P0134(front O2 sensor no activity) disabled from popping up, couldn’t fix it and read on a bunch of forums that it’s common if you have catless headers and it’s ok to disable.
P0140(rear O2 sensor no activity) popped up last week when I swapped tunes to see if my tune was causing it. I’ve found that to be common whenever I change tunes and it disappears in a day or two.
MrScrublord is offline   Reply With Quote
The Following User Says Thank You to MrScrublord For This Useful Post:
humfrz (01-30-2023)