Quote:
Originally Posted by KillerBMotorsport
-10 should be fine. That's the minimum size we recommend. Below that and you'll see a pressure drop.
I'm still stuck on the pressure drop you're seeing at temp. Odder knowing you've got a cooler, if anything that should stabilize pressure. It would be interesting to compare pre-cooler install to post-cooler pressures
|
Well, my sandwich plate does have ports to put 1/8 NPT sensor at inlet and outlet. But GR86 hood is too low so the sensor will hit the hood when closed. I tried 90 degree adapter before, but without good way to keep the sensor in place, it might become a failure point so I relocate the sensor to the block.
My oil pressure/temperature data matches pretty well with TrackAndBuild's GR86 which has a colorfitting oil cooler. So I don't think its my setup issue. I will try to draw a pressure/temperature chart once I have more data. Right now most of my oil pressure data are collected in winter and oil temperature didn't go very high.