Quote:
Originally Posted by villainous_frx
Other than the OBD2 port disagreeing with my Solo DL and throwing a CEL + limp mode, it was a struggle free set of 20 minute sessions.
|
Dug into this the past few days with Gerald and we've isolated the tracbox power to it's own switch thinking it might've been the issue. However with that fix, unfortunately the issue prevails and the car throws a U0073 when the Solo DL is plugged in. This was confirmed by fully unplugging the tracbox at the car and only the Solo DL being plugged in while the car was 100% off. I also tried data logging with a standalone OBD2 reader and the tracbox and there were no issues.
Because of that, I believe the issue is with the cable. As a potential bandaid I'm going to give an OBD2 extension cable a shot, as well as adjusting the pins on all of the OBD2 ports (male & female). If that does not work, I suppose I'll be hardwiring the Solo DL to CAN as I had intended.
On happier news, my header + tactrix + ff kit should be arriving any day now
