Quote:
Originally Posted by BayArea_FRS
Hey so I already had a tune installed for a while but was trying to change tunes. During installing the new tune it erased my ecu file like normal but then failed , So now I I have no ecu tune at all and can’t start my car. I’ve tried installing the same tune I was on and each time I do I get an error code 10010. I can’t even go back to the original file. I’ve been trying for the past 3 hours. And I’m in a parking garage where my car can get towed so I can’t leave my car.
This is the error
An error accused while writing the ECU. Check Cable connections, ignition switch positions, then try again later. OFTCODE: 10010
I’ve tried disconnecting the battery
Installing new tune files
Making sure all windows are up and doors closed
Checked cable connections
|
DId you ever figure this out? Its kind of frustrating that after all the work Open Flash did on making these tunes + making them flashable by the end user, they went with the cheapest shittiest tablets possible. I'd have gladly paid an extra 100$ to not have to pray to god every time I switch off E85