Quote:
Originally Posted by Ultramaroon
"Can't see it being..." is not a troubleshooting step. Have you actually tested the components in question? Looked for a signal? Also, why are you wasting your time with the sensor?
|
The sensor was swimming in oil due to the oil leak from the sandwich plate, and compared an ohms reading to another sensor which was ridiculously off, then tested it against the new sensor and the new one matched bank 1, leading me to believe it was a sensor issue.
As said before the solenoid has been replaced too, I don’t have tech stream or anything to retrieve the data to diagnose any further, so thought I’d post on here to see if anyone has experienced or have any ideas going forward before I take it in to the garage