|
I don't understand what you're saying about the vacuum line. Is it attached to the controller? The only things going to or coming from my controller are: 3 large wires going to the motor, 2 medium wires from the batteries, 2 large wires to the batteries, and a cable going to the switch and meter. So, when you say the compressor wheel spins, is it driven by the motor or just vacuum alone?
Also, I tried adjusting to pot on the switch and it doesn't seem to do anything noticeable. But I did notice that I do have speed control by how much pressure I put on the switch. I also noticed that running the motor with no load for a couple seconds, it doesn't even get warm. So that's good.
|