I'm not getting any communication with any modules that are linked to the can bus. I checked the terminal resistance on both the ECM and abs and both showed 120ohms which indicated that they are functional. But I measured canL and canH(pin6 and 14) with a multimeter it shows 0ohms. I also did the same on the abs connector hoping to at least get 120ohms since the abs is disconnected that will at least verify I have a connection. But it also shows 0ohms I’m not the best with electrical knowledge what could this mean and what's my next move? I'm getting power and everything works besides the immobilizer, steering, abs, and possibly ECM
Sent from my iPhone using Tapatalk