Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB - View Single Post

BAT_BRZ · 06-06-2022, 04:22 PM

Hi hivemind got a question for you all.

I am in the middle of a super charger install, took the direct injectors out and sent them out for cleaning!
Upon receiving the injectors I went to install them. I butter fingered one of them while trying to insert it into the fuel rail and it fell from my hands and fell on its injector tip.

After Drop

Side Shot:

Thankfully I have some high power microscopes and was able to clean the injector tip out and remove as much crap inside as I could. But I got this gut feeling that it might just be better to replace the injector and not risk having to rip the whole thing apart again and replace a bad injector. Here is what it looked like after cleaning

After Drop cleaning:

You can see there is still the slightest of something maybe in the side of the injector spray nozzle. So I thought I should order a new one.
But here is my problem. I cannot order the part number for the 2013 injector.

Part number# 16611JB000

I dug in deeper and found that I could only order

Part Number#16611JB030

So my question is, will this work? The injectors I need are marked #3 because there are 3 sets of injector types used on these cars. But the part number mismatch is making me worried I might just be better off installing the injectors that I had rather than mixing in 1 new injector.

06-06-2022, 04:22 PM	#1
BAT_BRZ Member Join Date: Dec 2016 Drives: 2013 Subaru BRZ "sti" Location: Orange County Posts: 35 Thanks: 31 Thanked 21 Times in 11 Posts Mentioned: 1 Post(s) Tagged: 0 Thread(s)	MY2013 BRZ with mixed injectors Hi hivemind got a question for you all. I am in the middle of a super charger install, took the direct injectors out and sent them out for cleaning! Upon receiving the injectors I went to install them. I butter fingered one of them while trying to insert it into the fuel rail and it fell from my hands and fell on its injector tip. After Drop Side Shot: Thankfully I have some high power microscopes and was able to clean the injector tip out and remove as much crap inside as I could. But I got this gut feeling that it might just be better to replace the injector and not risk having to rip the whole thing apart again and replace a bad injector. Here is what it looked like after cleaning After Drop cleaning: You can see there is still the slightest of something maybe in the side of the injector spray nozzle. So I thought I should order a new one. But here is my problem. I cannot order the part number for the 2013 injector. Part number# 16611JB000 I dug in deeper and found that I could only order Part Number#16611JB030 So my question is, will this work? The injectors I need are marked #3 because there are 3 sets of injector types used on these cars. But the part number mismatch is making me worried I might just be better off installing the injectors that I had rather than mixing in 1 new injector. Last edited by BAT_BRZ; 06-06-2022 at 04:25 PM. Reason: Posted to early.