Quote:
Originally Posted by Imti
All alignment tips are welcome.
|
I had to take the included washers out from inbetween the bolts and the shims to get the shims to back out enough and slip the tip on over the stock pipe. You'll probably need to do the same. Just slide them back until right before the pipe begins to curve to the muffler, youll notice when the tips start to point left or right instead of straight back. Then tighten the inside (top left for passenger side, top right for drivers side) bolt/shim first, then the bottom, then the 3rd one. Back up and look straight into the tip and make sure the stock pipe is centered inside the tip, then stand above the bumper and eyeball both tips to make sure they are even and one isn't sticking out farther than the other.