Hey guys,
I found this gauge "pod"
on thingiverse and was hoping to print one and get an OLED 0.96" screen to fit in there.
The problem is, apart from a little VBA I don't know jack about coding, and even less about Arduino coding.
Would anyone have the code needed to get the oil P&ID from the OBD2 and display it onto a small screen like
this one?
I found some code including how to get oil temp
here (thanks to that forum member!), but again, I don't know enough to pick & choose what I need from there.
Any help is welcome :-)
Best regards,
Alex