Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB - View Single Post

Secret · 02-26-2022, 10:55 PM

Hey guys. First time poster. Just installed my tomei expreme headers. Ran into a bit of an issue. For some reason my over pipe doesn't reach the header and I am bit stuck on what I should do. I am thinking about getting a C-Clamp (Tightening it) and seeing if that will fill the gap. Anyone else have any ideas? I was able to get everything else bolted down to the block without issue. I just for some reason think the front pipe is getting sucked back into the exhaust.

02-26-2022, 10:55 PM	#1
Secret Junior Member Join Date: Sep 2021 Drives: 2018 BRZ Limited Location: VA Posts: 5 Thanks: 0 Thanked 0 Times in 0 Posts Mentioned: 0 Post(s) Tagged: 0 Thread(s)	Header to Over Pipe Hey guys. First time poster. Just installed my tomei expreme headers. Ran into a bit of an issue. For some reason my over pipe doesn't reach the header and I am bit stuck on what I should do. I am thinking about getting a C-Clamp (Tightening it) and seeing if that will fill the gap. Anyone else have any ideas? I was able to get everything else bolted down to the block without issue. I just for some reason think the front pipe is getting sucked back into the exhaust. Attached Images Last edited by Secret; 02-26-2022 at 11:06 PM. Reason: To add a bit.