Quote:
Originally Posted by steve99
If your calid is ZA1JD00C thats a 2015 manual using tactrix flash a ZA1JA01G rom
|
So I flashed it with a 2013 V4 oft ROM. What definitions do I need to have for on ECU flash when I load up my ROM to flash it do I just use the ECU flash 13 BRZ ROM definition?
I am having this weird issue where I am unable to read the ROM it just says requesting seed then closing interfaces and error immediately.
reading vehicle info...
[16:54:00.442] CALID : ZALJA01G
[16:54:00.444] CVN 6039568A
[16:54:00.449] VIN : JF12NA
[16:54:00.569] starting programming session...
[16:54:00.570]
turning off DTCs...
[16:54:00.581] turning off unnecessary communications...
[16:54:00.582] unlocking ECU..
116:54:00.582]
Requesting Seed...
[16:54:00.585] interface close
[16:54:00.586]
interface close
EDIT! I think it was cuz my OBD2 port wasn't getting a good connection . I forced the plug tight against it and it seemed to flash again