Finally got my alignment done following the install of the H&R springs. I asked that they get the camber even side to side, and the fronts equal to or slightly more negative than the rear, with zero toe in front and just a tiny bit of toe-in in the rear.
Final settings were zero toe, -2.2 degrees camber both sides in the front, and -0.05" toe each side and -2.1 degrees camber both sides in the rear.
Caster is slightly different from left to right (same as it was before), with 6.4 degrees left / 6.6 degrees right.
This is all with a 1.25" drop from the springs, plus Pedders caster/camber front top mounts and 14mm camber bolts in the bottom holes on the stock struts.
Here's the before:
...and here's the after:
