[Target70]

Originally Posted by Qwimby1

I noticed that the three wires from the controller to the compressor lay right on top of the radiator hose, at least on my install. After a drive today they were very hot and the rubber insulation even seemed a little soft. I'm going to put some kind of heat insulation on both the wires and the hose before I drive it again.

My kit came with this plastic split tubing, which I put around the compressor wires. Also I would suggest you individually wrap or space the 3 connectors apart inside of any other insulation. At least one user had arcing burns between those connectors when vibrations or something caused the connectors to slightly come apart while being so close together.