Quote:
Originally Posted by Spuds
Ok, question on the wheel. What % of the torque do you actually use? Why would someone pick the dd1/2 over the csl dd now that the latter is available? Is 8nm just not enough torque for some folks?
|
43% though a bit lower at the moment due to some health issues... but had been looking toward 45% and feeling my way around any more or less.
I got the DD1 because I wanted a direct-drive setup and it was among the most affordable (and supported) bases available. I'm not sure I'd get it over the CSL DD base were I shopping now, but that wasn't available when I got this.