Quote:
Originally Posted by PhatFreshPrince
There are two USB ports in the cupholder area. I was wanted to add space for my phone in front of the gear shifter. There is room to put your phone there without the cover, but it is tight. It will stick in there straight, but it might get hot in there. Also, if I remove the cover then I can put my phone there sideways without it hitting the gear shifter. Man, just like 5 more mm and it would have worked.
|
When you says it's a tight fit, is that length, width, and/or thickness? This seems like the best/obvious place to put one. Even if we had to cut the tabs, if someone 3D prints a cubby that works well I would think demand would be high.
I have a magsafe cheeseplate mount I was planning on bolting to the console right where the cupholder is on ATs. I've installed them before and looks super clean, but a printed cubby would be even better if it will fit plugged in.