|
Having major issues with my oil temp sensor as well as coolant. Odd that both would have any issues as the coolant temp sensor ohms match the heat range I tested it at. The Bosch oil sensor reads pressure just fine so weird that temp would be a problem. I haven't tested ohms to temp yet but will in a minute. Also my MAP sensor is reading around -78 kpa at about 1300 rpm or so. My idle won't drop probably because both temp sensor readouts are trash.
Ugh.
I've sent a message to Kpower to see if they can help rule out possible issues but other than plugging in their harness which can only be done one way there shouldn't be much I could have screwed up. I do know the coolant temp sensor on the k24 was working before I pulled the engine from the donor. Odds that it's bad seem really low. Also really weird that the oil temp sensor would be doing the same.
One thing I did confirm is that the fans only kick on during defrost using heater only. That's a relief. Now if I could get things to read right I could drive my dang car!
|