Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB - View Single Post

trxn · 10-31-2021, 07:10 PM

Got a set of OEM zenki taillights with the intention to clearing them out. Cut them open and spray painted the red parts silver. Used epoxy to glue some parts back together. Used 3D printer PLA filament and soldering iron to bond the lens and backing together. Noticed after a day of driving in the rain, the left side had some condensation but the right side was dry. Going to go back and check the left side for holes again.

10-31-2021, 07:10 PM	#94
trxn Senior Member Join Date: Jul 2017 Drives: 2017 Toyota 860 Location: DMV Posts: 144 Thanks: 43 Thanked 74 Times in 59 Posts Mentioned: 0 Post(s)	Clear Zenki Taillights - 09.07.2021 Got a set of OEM zenki taillights with the intention to clearing them out. Cut them open and spray painted the red parts silver. Used epoxy to glue some parts back together. Used 3D printer PLA filament and soldering iron to bond the lens and backing together. Noticed after a day of driving in the rain, the left side had some condensation but the right side was dry. Going to go back and check the left side for holes again. __________________ @li.motive