Quote:
Originally Posted by almostquick
I’m curious as to how you did your bucket seat setup. Are you using the Bride seat, with aftermarket rails, and the factory seat belts? Did you happen to use a buckle extender on the center console side to have body contact with your lap belt?
|
Bride Zeta IV, Bride FO Rail, 2.2 Ohm resistor soldered to a cut off OEM airbag clip (full plug & play). For the seat belt, I use the OEM buckle flipped around and bolted to the FO rail. The belt is also routed through the left (sitting in seat) hole and then across the waist. Other seat accessories I have are a Bride Side Cover Pocket, and a Bride Bucket Seat and Reclining Seat Optional Parts Seat Belt Guide.
This post also has another picture, and I believe there are a few more through the thread.
https://www.ft86club.com/forums/show...7&postcount=51
If I had to do it again, I would ditch the sliders and get a PCI/Bride solid mount.
