@
Kodename47 coming back to this again...
For the WOT Best VVT calculation this was mentioned in the wiki:
Quote:
|
VVT System #1 (Note: Use a log parameter that replicate the VVT table values, this may be different to actual VVT angle dependent on the system.
|
I'm trying to understand the reason why you would use commanded values instead of actual values... I would think that it was intended for more consistency, and to remove overshoot or values a distance from targets.
Thing is none of the current Tactrix log files are able to log the commanded AVCS, you could use OBD2 PIDs but the capture speed probably isn't enough. I did a comparison, feeding actual and commanded values (created a new column to to put table values where RPM and load is concerned) and there isn't a major difference; mostly the same on midrange but +5/-5 degs away at redline.