Quote:
Originally Posted by Irace86.2.0
Why can’t you? Not strong enough? The FA20 intake manifold is plastic. No reason the spacer couldn’t be plastic. You could make a cast piece yourself out of aluminum from soda cans, but the time isn’t worth it probably. It isn’t too hard to do. Seen it on YouTube channels.
If this doesn’t work out, you could join the K24 swap team. Third time is a charm, they say.
|
The layer lines create a fault point. If it was staying N/A I could most likely get away with it, but under boost may cause some issues. I may end up running it as a test for a bit while the car is still being built.
My old boss has a 5 axis CNC machine, so getting it milled shouldn't be an issue, just costly for such a large chunk of aluminum. Especially for a one off part. Though then if anyone else needed one, they could get it made pretty easy.